Sign Up Now
FREE E-Newsletter

Search



ABOUT SSL CERTIFICATES

 
Echo™ Beta Specification

Echo™ Beta Specifications Subject to Change Without Notice

Sensor Module Measurements   
RMS Velocity  
RMS Acceleration  
True Peak Acceleration  
Battery voltage at maximum load  
System Information Provided  
Date  
Time  
Sensor ID  
RMS Velocity  
Derived Peak Velocity  
RMS Acceleration  
Derived Peak Acceleration  
True Peak Acceleration  
Crest Factor  
Battery Status  
RF Status  
Radio & Standard Specification
Radio Standard Propietary Extended Range RF (ERRF)
Modulation Mode Narrowband Frequency Shift Keying (NFSK)
Noise Floor -155dBm
Radio Sensitivity -145 dBm
Frequency Band (unlicensed) 902-928 MHz US
Maximum Power (ERP) 1 mW
Maximum Transfer Rate 20 bps
Typical Power vs Transfer Rate 20 bps @ -145 dBm sensitivity
Sensor Programming Adapter 9-pin, RS232 interface
Programming Adapter-to-Sensor Interface CMOS Signal over micro USB connector
Number of receivers handled by a single computer 1
Sensors/receiver @ 3 meas/day, 1% miss rate ~800
Sensors/receiver @ 3 meas/day, 5% miss rate ~4000
Antenna Integral 1/2" Ceramic
Performance Specification
RMS Velocity Digital Integration
  Velocity HP Filter 2 Hz, 1-pole RC
  Velocity LP Filter 2500 Hz, 3-pole Chebyshev
  Velocity Resolution 0.001 ips
Derived peak velocity 1.414 x RMS Velocity
RMS Accleleration (HFE) Time Sample Sum
  Acceration HP Filter 2500, 4-pole Chebyshev
  Acceration LP Filter 15,000, 3-pole Chebyshev + 1-pole RC
  Acceleration Resolution 0.005 g
Derived Peak Acceleration 1.414 x RMS Acceleration
True Peak Acceleration (absolute value) ≥50 μs pulse width
Crest Factor True Peak / RMS Acceleration
ADC/dynamic range 16 bit / >90 dB 
Measurement Range ± 20 g
Frequency Response (±3 dB) 3 Hz to 15 kHz
Residual Vibration Level (RVL)  
  If RVL = 0 Collect on normal interval
  If RVL > 0 Collect data if RMS velocity > RVL
Operation Verification LED
Environmental Specification
Overload Limit (Shock) TBD
Temperature Range (Electronics) -20° to 70° C
Temperature (Base) -54° to 121° C
Humidity 5% - 95%, non-condensing
Sensor Module Enclosure Rating TBD
Electrical Specification
Power Saft 7.2V Lithium Battery, SR181263
  Replaceable Yes
Electrical Isolation (Case) >108 ohm
Physical Specification
Sensor Module Dimensions  
  Base Assembly 1-3/8" Hex
  Housing 1.6" Dia
  Height (overall) 4.5"
Weight (including battery pack) 444 g
Mounting Thread 1/4-28 Female
Mounting Torque 2 to 5 ft-lb
Sensing Element (IMI 66213LPZ1) Ceramic Shear
Sensor Module Material  
  Base Stainless Steel
  Housing Material  Stainless Steel
  Housing Cap (passes RF signal) Ploycarbonate
  Mechanical Isolator Urethane
Mounting 1/4-28 Stud
Sealing TBD
Data Storage Specification
Format ODBC